|تعداد مشاهده مقاله||23,672,174|
|تعداد دریافت فایل اصل مقاله||21,749,170|
Investigating the wind-induced effects on Tall Buildings to reduce Drag Coefficient through Large Eddy Simulation (LES)
|International Journal of Architecture and Urban Development|
|مقاله 1، دوره 13، شماره 2 - شماره پیاپی 48، تیر 2023، صفحه 5-14 اصل مقاله (1.83 M)|
|نوع مقاله: Applied Article|
|شناسه دیجیتال (DOI): 10.30495/ijaud.2022.67658.1612|
|Najmeh Mastari Farahani1؛ Abdollah Baghaei Daemei 2؛ Payam Madelat3؛ Seyedeh Maryam Abbaszadegan4|
|1Faculty member and Instructor, Department of Architecture and Urbanism, Technical and Vocational University, Alborz, Iran.|
|2School of Built Environment, College of Science, Massey University, Auckland, New Zealand|
|3School of Engineering, Department of Civil Engineering and Architecture, Tallinn University of Technology, Estonia|
|4Faculty of Architecture and Urbanism, Soore University, Tehran, Iran|
|Wind load in architectural engineering can be defined as the natural load produced by air and is considered the most vital factor in design because this load significantly impacts structures, especially tall buildings. In this regard, drag force is the crucial wind force in tall building design. Even if the structure's safety is verified by using advanced technologies and high-quality materials, the vibrations caused by the wind force can still reach beyond the human comfort zone and may cause concern. The main goal of this study is to identify the wind aerodynamic factors in the urban boundary layer and evaluate the drag coefficient in tall-square buildings. Seven sample squared-plan buildings with aerodynamic modifications (corners) including recessed, rounded, and chamfered corners, and aerodynamic forms including set-back, tapered, and helical/twisted compared to the base (sharp corner) model. Autodesk Flow Design 2014 software was performed as a wind tunnel simulator. The software utilizes a Large Eddy Simulation (LES) turbulence model solver to account for turbulence within the wind tunnel. LES is a mathematical model for turbulence used in computational fluid dynamics of the atmospheric boundary layer. The results showed that the sq6 with the aerodynamic tapered form had the best performance compared to other samples, which was about 50%. The sq3 sample with chamfered aerodynamic modification could reduce the building's drag coefficient and wind effect by about 42%.|
|Wind aerodynamics؛ Urban boundary layer؛ Wind tunnel simulation؛ Drag coefficient؛ Tall buildings|
Amin, J.A. Ahuja, A.K. (2014). Characteristics of wind forces and responses of rectangular tall buildings. International Journal of Advanced Structural Engineering, 6(3), 66.
Arakeri, J. H. & Shankar, P. N. (2000). Ludwig Prandtl and boundary layers in fluid flow. Resonance, 5(12), 48-63.
Cermak, J.E. (1975). Applications of fluid mechanics to wind engineering—a Freeman Scholar lecture. Journal of Fluids Engineering. 97(1), 9–38.
Chan, C.M., & Chui, J.K.L. (2006). Wind-induced response and serviceability design optimization of tall steel buildings. Engineering Structures, 28 (4), 503–513.
Chan, C.M., Huang, M.F., Kwok, & K.C.S. (2009). Stiffness optimization for wind-induced dynamic serviceability design of tall buildings. Journal of Structural Engineering, 135 (8), 985–997.
Currie, I. G. (1974). Fundamental Mechanics of Fluids, McGraw-Hill, Inc.
Davenport, A.G. (19710. The response of six building shapes to turbulent wind. Royal Society, 269, 385–394.
Elshaer, A., Gairola, A., Adamek, K., & Bitsuamlak, G. (2017). Variations in wind load on tall buildings due to urban development. Sustainable Cities and Society, 34, 264-277.
Fadl, M.S. & Karadelis, J.N. (2013). CFD simulation for wind comfort and safety in urban area: a case study of Coventry university central campus. International Journal of Architecture. Engineering and Construction (IJAEC), 2(2), 131-143.
Autodesk (2014). Flow Design Preliminary Validation Brief, Retrieved from: http://download.autodesk.com/us/flow_design/Flow_Design_Preliminary_Validation_Brief_01072014.pdf.
Gu, M., Huang, P., Tao, L., Zhou, X., & Fan, Z. (2010). Experimental study on wind loading on a complicated group-tower. Journal of Fluids and Structures, 26, 1142–1154.
Gu, M., Cao, H.L., & Quan, Y. (2014). Experimental study of across-wind aerodynamic damping of super high-rise buildings with aerodynamically modified square cross-sections. The Structural Design of Tall and Special Buildings. 23, 1225–1245.
Günel, M.H., & Ilgin, H.E. (2014). Tall Buildings Structural Systems and Aerodynamic Form, First published, Routledge, Taylor & Francis Group, New York.
Holmes, J.D. (2001). Wind Loading of Structures, London: Spon Press.
Hu, J.C., Zhou, Y., & Dalton, Y.C. (2006). Effects of the corner radius on the near wake of a square prism. Experiments in Fluids, 40, 106–118.
Huang, M.F., Chan, C.M., & Kwok, K.C.S. (2011). Occupant comfort evaluation and wind induced serviceability design optimization of tall buildings. Wind and Structures, 14 (6), 559–582.
Rafizadeh, H., Alaghmandan, M., Tabasi, S. F., & Banihashemi, S. (2022). Aerodynamic behavior of supertall buildings with three-fold rotational symmetric plan shapes: A case study. Wind and Structures, 34 (5), 407–419.
Irwin, P.A., Kilpatrick, J., Robinson, J., & Frisque, A. (2008). Wind and Tall Buildings: Negatives and Positives. Structural Design of Tall and Special Buildings. 17, 915–928.
Kawai, H. (1998). Effect of corner modifications on aeroelastic instabilities of tall buildings. Journal of Wind Engineering and Industrial Aerodynamics, 74(76), 719-729.
Kikitsu, H., Okuda, Y., Ohashi, M., & Kanda, J. (2008). POD analysis of wind velocity field in the wake region behind vibrating three-dimensional square prism. Journal of Wind Engineering and Industrial Aerodynamics, 96, 2093–2103.
Kim, Y., and Kanda, J. (2010). Characteristics of aerodynamic forces and pressures on square plan buildings with height variations. Journal of Wind Engineering and Industrial Aerodynamics, 98(8–9), 449-465.
Kim, Y.C., Kanda, J., & Tamura, Y. (2011). Wind-induced coupled motion of tall buildings with varying square plan with height. Journal of Wind Engineering and Industrial Aerodynamics, 99(5), 638-650.
Li, Q.S., Zou, X.K., Wu, J.R., & Wang, Q. (2011). Integrated wind-induced response analysis and design optimization of tall steel building using micro-GA. Struct. Des. The Structural Design of Tall and Special Buildings, 20, 951–971.
McCormick, B.W. (1979). Aerodynamics, Aeronautics, and Flight Mechanics. New York: John Wiley & Sons, Inc.
Mendis, P., Ngo, T., Haritos, N., & Hira, A., (2007). Wind loadings on tall buildings. EJSE Special Issue: Loading on Structures, 41, 1–14.
Mittal, H., Sharma, A., & Gairola, A. (2018). A review on the study of urban wind at the pedestrian level around buildings. Journal of Building Engineering, 18, 154-163.
Mochida, A., & Lun, I.Y.F. (2008). Prediction of wind environment and thermal comfort at pedestrian level in urban area. Journal of Wind Engineering and Industrial Aerodynamics, 96(10–11), 1498-1527.
Moreno, J. (1989). Analysis and Design of High-Rise Concrete Buildings, ACI SP-97 Series, Michigan: American Concrete Institute.
Parker, D., & Wood, A. (2013). The Tall Buildings Reference Book. First published, Routledge, Taylor & Francis Group, USA.
Potter, M.C., Wiggert, D.C., & Ramadan, B.H. (2011). Mechanics of Fluids, (Fourth edition. ed.), Thomson Wadsworth publisher, 105.
Rott, N. (1990). Note on the history of the Reynolds number. Annual Review of Fluid Mechanics, 22 (1), 1–11.
Shiqing, H. Xuhui, H. & Hua, H. (2017). Characteristics of the aerodynamic interference between two high-rise buildings of different height and identical square cross-section. Wind and Structures, 24(5), 501-528.
Stathopoulos, T. (2009, July). Wind and comfort. In 5th European and African Conference on Wind Engineering, EACWE 5, Proceedings.
Sullivan, P.P. McWilliams, J.C. & Moeng, C.H. (1994). A subgrid-scale model for large-eddy simulation of planetary boundary-layer flows. Boundary-Layer Meteorology, 71(3), 247–276.
Tamura, T. & Miyagi, T. (1999). The effect of turbulence on aerodynamic forces on a square cylinder with various corner shapes. Journal of Wind Engineering and Industrial Aerodynamics, 83(1–3), 135-145.
Tamura, T. Miyagi, T. & Kitagishi, T. (1998). Numerical prediction of unsteady pressures on a square cylinder with various corner shapes. Journal of Wind Engineering and Industrial Aerodynamics. 74(76), 531–542.
Tanaka, H. Tamura, Y. Ohtake, K. Nakai, M. & Kim, Y.C. (2012). Experimental investigation of aerodynamic forces and wind pressures acting on tall buildings with various unconventional configurations. Journal of Wind Engineering and Industrial Aerodynamic, 107(108), 179-191.
Tominaga, Y. Mochida, A. Yoshie, R. Kataoka, H. Nozu, T. Yoshikawa, M. & Shirasawa, T. (2008). AIJ guidelines for practical applications of CFD to pedestrian wind environment around buildings. Journal of Wind Engineering and Industrial Aerodynamics, 96 (10–11), 1749-1761.
Wahrhaftig, D.M.A., & Da Silva, M.A. (2018). Using computational fluid dynamics to improve the drag coefficient estimates for tall buildings under wind loading. The Structural Design of Tall and Special Buildings, 27, e1442.
Hall, N. (2015). What is drag? Retrieved from: www.grc.nasa.gov/www/k-12/airplane/drag1.html
Xie, J. (2012). Aerodynamic optimization in super-tall building designs. 7th International Colloquium on Bluff Body Aerodynamics and its Applications (BBAA7). Shanghai, China; September: 2-6.
Xie, J., (2014). Aerodynamic optimization of super-tall buildings and its effectiveness assessment. Journal of Wind Engineering and Industrial Aerodynamics, 130, 88-98.
Xu, Z., & Xie, J. (2015). Assessment of across-wind responses for aerodynamic optimization of tall buildings. Wind and Structures, 21(5), 505-521.
Yasa, E. (2016). Computational evaluation of building physics—The effect of building form and settled area", microclimate on pedestrian level comfort around buildings. Building Simulation, 9(4), 489–499.
Zhi, L., Chen, B., & Fang, M. (2015). Wind load estimation of super-tall buildings based on response data. Structural Engineering & Mechanics, 56 (4), 625-648.
Zhiyin, Y. (2015). Large-eddy simulation: Past, present, and the future. Chinese Journal of Aeronautics, 28(1), 11-24.
Baghaei Daemei, A., Eghbali, S., Moez, H., & Bahrami, P. (2019). Wind tunnel flow simulation and aerodynamic shape optimization of tall buildings to improve the drag coefficient under wind forces. Hoviatshahr, 13(2), 63-80.
Lucy Marsland, Khanh Nguyen, Yichi Zhang, Yuemin Huang, Yousef Abu-Zidan, Tharaka Gunawardena, Priyan Mendis, (2022). Improving aerodynamic performance of tall buildings using façade openings at service floors, Journal of Wind Engineering and Industrial Aerodynamics, 225, 104997.
Yi Li, Qian Song, Chao Li, Xuan Huang, Yan Zhang, (2022). Reduction of wind loads on rectangular tall buildings with different taper ratios, Journal of Building Engineering, 45, 103588.
Lei Zhou, K.T. Tse, Gang Hu, (2022). Experimental investigation on the aerodynamic characteristics of a tall building subjected to twisted wind, Journal of Wind Engineering and Industrial Aerodynamics, 224, 104976.
تعداد مشاهده مقاله: 128
تعداد دریافت فایل اصل مقاله: 80